-
Temperature Transmitter
1 × $16.50 -
Door Hinge, Lower Left Hand, Morris Minor
1 × $94.04 -
Door Hinge Kit, Studs Nuts Bolts & Washer Kit For Alloy Hinges
1 × $39.05 -
Rocker Arm Bush
1 × $7.15 -
Valve Cotter, Pair
1 × $9.90 -
Door Handle, Pull Cable
1 × $99.00 -
Door Handle Link Lever, LH
1 × $24.64 -
Door Hinge, LH Upper
1 × $25.30 -
Door Check Strap Seal, Right Hand
1 × $9.90 -
Oxygen ambient air sensor with Rover Mini Fuel injected
1 × $90.75 -
Headlamp Bucket Kit, (Bowl) Suit 7'' Lamps - CHROME BEZEL
1 × $40.00 -
Rotor Arm, Suit Ducellier Distributor
1 × $7.59
Engine
-
$24.20
Screw – Tappet Adjusting, 7/16 UNF , Fitted to all “Pressed” Rocker Arms
Except those fitted to the 1275cc
This screw is sold each, Qty 8 Required per vehicle
The nut fitted to this screw is # 6K654
-
-
$356.02
Temperature Pressure Compensator SPI TPC
-
-
$35.81
Coolant Temperature Transmitter
This transmitter is denoted by it’s black plastic end. Mounted to the underside of the inlet manifold.
-
-
-
$71.50
Thermostat Housing
These were fitted to late model 76>81 Moke’s and Mini’s, the outlet faces the firewall not the front like on the earlier cars.
-
$55.00
Thermostat Housing, Forward Facing
With Temperature Gauge Hole
-
$19.80
This is the spacer that sits between the engine support bracket and the thermostat housing on 1976 onwards (rear facing setup)
-
$2.82
Thermostat Housing Stud 48mm (1.9375″) Long
This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required.
5/16″ unc and unf at nut end, this stud is about 5cm long about 4cm from the bottom of the UNC thread
-
$5.57
Thermostat Housing Stud, 48.mm (1.9375″) Set Of 3
This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required.
5/16″ unc and unf at nut end, this stud is about 5cm long about 4cm from the bottom of the UNC thread
-
$2.86
These are the special studs for the thermostat housing – 5/16 dia x 52mm o/all length with unc one end and unf the other.
Suits housings without engine steady bracket.
-
$5.25
Thermostat Housing Stud, 76 mm
If your thermostat has a sandwich plate under it, you will need these longer studs. The washers are # GFK1114 and the nuts are # FNZ505.
5/16″ bolt 3″long, unc bolt with unf nut end.
Also used as a differential housing to case stud.
-
$82.50
Thermostat Housing, to suit Late 1275 Moke and 1275 LS Mini’s.