You have no item(s) in your cart
Series II and IIA 1958-1970
-
Availability: This product is currently out of stock.
SWING AWAY SPARE WHEEL CARRIER REAR
-
$14.99
Stop Light switch for Servo fitted vehicles. Can be used as a Reverse Light switch suitable for various models;
– Defender
– Series L/R
– Land Rover 110
– MGB -
$215.00
Converts early spring & pin type swivel models to later railko bush type system.
Kit includes:- Railko Bushes, Swivel Pins, Tab Washers, Shims, Gaskets, Split Pins
Suits Land Rover Series 2 & 2A
-
$380.00
Converts early spring & pin type swivel models to later railko bush type system.
Kit includes:- Swivel pin bearings, Felt hub seals, Railko Bushes, Swivel Pins, Tab Washers, Shims, Gaskets, Split Pins
Suits Land Rover Series 2 & 2A
-
-
Availability: This product is currently out of stock.
T-JUNCTION, BRAKE PIPE FEMALE CONNECTOR 3/8″ X 24 UNF
-
-
$39.00
Timing Chain Tensioner for 2.25L petrol/diesel
Suits Land Rover Series 2, 3 & Defender
-
$1.10
Rear shock absorber, lower bush guide washer.
Suits Land Rover Series 2 & 3, Defender, Discovery 1 & 2, Range Rover Classic, P38
-
$13.00
Dished pinion thrust washer for centre diff gears on the LT95 gearbox.
Suits Land Rover Series 1, 2 & 3, Early Defender, Perentie, Range Rover Classic 1971 – 1986.
-
$24.00
Greaseable Left Hand Thread Tie Rod End suitable for;
– Series 1 LR
– Series 2/2A LR
– Series 3 LR -
$24.00
Right Hand Thread, Greaseable Tie Rod End suitable for;
– Series 1 LR
– Series 2/2A LR
– Series 3 LR -
-
$1.50
Leaf spring U bolt nut. Self locking 7/16″ BSF
Suits Land Rover Series I, II & III
-
$44.00
Voltage stabiliser for Smiths & Jaeger Instruments.
Provides 10 volt feed to Smiths gauges. Negative Earth only.
Note the outer casing of the unit should be earthed.
One voltage stabiliser is enough to run up to 3 Smiths gauges.
If you are having trouble with your fuel gauge and your temperature gauge its a pretty safe bet that this little box is the cure for your troubles.
They do wear out and they are often found to be putting out an incorrect voltage