You have no item(s) in your cart
MINI
-
-
-
Availability: This product is currently out of stock.
“T” Piece, Oil Gauge & Switch
Mini
-
-
-
-
-
-
$8.80
Tube, Air Pre-Heat Duct,
Fitted between the air temperature control and # 12G3213
-
$24.39Add to cart
Twin Carb Choke Link Shaft.
Rod with chamfered ends about 57.2mm long (shorten to 54mm for twin HS4) which has AUE586 and AUE587 clamps to fit between SU twin carbs for the linkage.
-
$104.50Add to cart
Twin Carburettor Linkage Kit
This kit will suit all the later 1.25″ and 1.5″ twin carb set ups where the balance rods between the carbs are equal in length (2.25″) Some early model carbs had the balance bar with a triangular plate, this is a shorter length.
-
$206.59
Twin Carburettor Manifold Suit 1-1/2″ SU
Can be modified to suit 1-3/4″ SU
Made in UK
Cast alloy type, Fits either twin HS4 or HS6 (requires modification to fit HS6. 2 extra studs per carb) This intake manifold for twin SUs has been carefully produced to minimize cross-port-flow interference caused by the balance tube and has generous radii in all the right places. Further blending can be done if required, but leave a ground finish to promote fuel atomization. Do NOT polish!
-
$242.00Add to cart
Twin Carburettor Manifold Suit 1-1/4″ SU
Made in UK
Cast alloy type, this intake manifold for twin SU’s (H2, HS2 or H4 — NOT HS4) It has been carefully produced to minimize cross-port-flow interference caused by the balance tube and has generous radii in all the right places.
Further blending can be done if required, but leave a ground finish to promote fuel atomization. Do NOT polish!
-
$0.85
Universal Joint U-Bolt Nut
5/16″ Nyloc
-
$496.50Add to cart
Ultra light (8.38lbs) EN8 steel billet race flywheel
For non-Verto clutch with ring gear for non-pre-engaged starter.
Not recommended for road use. (See AEG421C FOR FAST ROAD)