You have no item(s) in your cart
Engine
-
$99.00
Timing Gear Kit, Duplex
-
-
$11.00Add to cart
Timing Gear single row chain fitted to camshaft, suit most A series engines
This is a second hand unit in good condition
-
-
-
$8.80
Tube, Air Pre-Heat Duct,
Fitted between the air temperature control and # 12G3213
-
$206.59
Twin Carburettor Manifold Suit 1-1/2″ SU
Can be modified to suit 1-3/4″ SU
Made in UK
Cast alloy type, Fits either twin HS4 or HS6 (requires modification to fit HS6. 2 extra studs per carb) This intake manifold for twin SUs has been carefully produced to minimize cross-port-flow interference caused by the balance tube and has generous radii in all the right places. Further blending can be done if required, but leave a ground finish to promote fuel atomization. Do NOT polish!
-
$242.00Add to cart
Twin Carburettor Manifold Suit 1-1/4″ SU
Made in UK
Cast alloy type, this intake manifold for twin SU’s (H2, HS2 or H4 — NOT HS4) It has been carefully produced to minimize cross-port-flow interference caused by the balance tube and has generous radii in all the right places.
Further blending can be done if required, but leave a ground finish to promote fuel atomization. Do NOT polish!
-
$496.50Add to cart
Ultra light (8.38lbs) EN8 steel billet race flywheel
For non-Verto clutch with ring gear for non-pre-engaged starter.
Not recommended for road use. (See AEG421C FOR FAST ROAD)
-
-
-
$9.90Add to cart
Valve Cotter, Pair
All the earlier heads used the 2A11 cotters, noted by the wide slot in the valve.
Later production and most aftermarket valves, use this 88G459 collet/keeper with a single narrow groove Pre APlus.
Valve stems with 3 grooves as used on most A-Plus heads,use CAM6975 cotters. Order the correct cotters to go with the valves you will be using.
When ordering these you get two halves to equal one cotter for one valve.
Mini valve collet- radius groove (per single collet) 2 required per valve- x 16 per engine
-
-
-