You have no item(s) in your cart
Engine
-
$19.25
Exhaust Clamp, Pipe to Manifold. 2″ Diameter
-
-
$85.34Add to cart
Exhaust Valve, 30.97 mm diameter (1.22″ (31mm) x 3.52″)
As it is possible, even common, to swap one head for another on 1275 engines, it is quite easy to become confused, or worse yet, confuse the parts-guy when it is time to order new valves! Be aware that if the head has been worked on previously, it may have oversize valves; it may have undersize if seats have been installed. Unless you are 100% sure what is in your cylinder head, it is a good idea to remove a valve for accurate measurement. There are two lengths used (nominally 3.52″ & 3.57″) three different keepers, (wide, narrow, and three-groove) and many different head diameters!
-
$45.01Add to cart
Race Quality Exhaust Valve, 29.5 mm 1.161″
This is a competition quality heat treated valve to minimise wear problems caused by unleaded fuel.
Single radius groove for collets.
Made from EN214N steel, stellite tipped
-
$22.00
Exhaust Valve, Mk2 Cooper S 1275
Single Radius Collet Groove
1.161″
-
$15.40Add to cart
Exhaust Valve Late 998cc Mini & Moke,
Single Radius Small Collet Groove 1″ wide
0.220″ from valve tip
Qty 4 per engineUse AEA311 Spring
-
-
-
-
$8.25
Fan Belt, Suit Generator
Fitted to most cars pre 1980 with either dynamo or alternator, plus 998 from 1985 and 1275 from 1990 when smaller pulley was used, this was mainly on automatic cars.
# 2A601 pulley 3.875″ wide and # CAM6408 pulley used from A plus onwards is 4.265″ wide.
-
$104.50Add to cart
Flywheel Puller
Don’t try to remove the flywheel on a Mini or Moke without one of these special pullers. The tapered seat must by design be extremely tight and this special puller leverages in the correct place to make removal possible. And since you can not change the clutch without pulling the flywheel every owner must have one of these. Does both pre verto & verto engines.
-
$3.63Add to cart
Fuel Hose, Mechanical Pump to Carby to suit Mini-Matic Models. This part is New Old Stock.
-
$14.30
Fuel Pump Blanking Plate. Use When Not Fitting Mechanical Fuel Pump
-
$29.72Add to cart
Fuel Pump Spacer, Suit Mechanical Fuel Pump
0.49″ Thick
The gaskets are available separately # GUG705779GM
-
$1.32Add to cart
Fuel Pump to Block Gasket. This is the Paper gasket for either side of the spacer on all mechanical fuel pumps fitted on the rear of engines.
Qty 2 will be required when a spacer is fitted.
The 12mm spacer with gaskets fitted is available as GUG705603GM