You have no item(s) in your cart
COOPER S
-
-
-
-
-
$82.50
Heater Tap, Straight Type
Used mainly on Cooper S and Moke
-
-
$440.00Add to cart
Roller Tip Rocker Kit 1.5:1 Less Spacers
Hi-Lift forged rockers on special rocker shaft with AEG167 adjuster screws for road or race. When fitting make sure posts are equally tightened down this should eliminate stress fractures of the shaft.
Using 1.5 ratio high lift rockers has become very popular as they are effective at high revs
This 1.5 ratio forged rockers set will replace the standard versions and give significant gains on 1275cc units.Kit contains 8 rockers, adjusting screws, 4 steel pedestals and a heavy duty rocker shaft.
Valve clearances are recommended to be opened up by .003″ over recommended settings, although up to .005″ can be beneficial with certain combinations. Using the 1.5 ratio not only increases the maximum lift but it also means that the valve is open approximately 20% more at any given point- although opening and closing periods remain the same. This vastly improves volumetric efficiency and therefore power output
-
-
-
$51.70Add to cart
OE Door Hinge Panel, Left Hand.
For all Minis with internal hinges and doors that have wind up windows. Although it is a single wall panel it still has a tendency to develop rust spots
For external door hinge Minis use # 14A6902
New Old Stock
-
-
$51.70Add to cart
OE Door Hinge Panel, Right Hand.
For all Minis with internal hinges and doors that have wind up windows. Although it is a single wall panel it still has a tendency to develop rust spots
For external door hinge Minis use # 14A6901
New Old Stock
-
$2.20Add to cart
The hinge pin that holds the float bowl in place on the float bowl lid.
Suits 1-1/4″, 1-1/2″ & 1-3/4″ Carby’s
-
$16.50Add to cart
Battery Hold Down Rod (Front)
This is the open loop rod by the negative terminal which hooks into the battery box bracket # HAM2457
-
$9.38Add to cart
Hold Down Rod, For Battery (Rear)
Battery Rear Bolt – 6cm- Loop End
This rod fits on the back bracket by the positive earth terminal with a nut and bolt.