You have no item(s) in your cart
Engine
-
$264.28
Harmonic Balancer, To Suit AEG454 Pulley As Fitted To Cooper S
Can Be Used On 998 1098 cc Engines
-
-
$261.42Add to cart
Heater Hose
For injection model’s only
T-shape from thermostat to inlet manifold and heater valve
-
-
$440.00Add to cart
Roller Tip Rocker Kit 1.5:1 Less Spacers
Hi-Lift forged rockers on special rocker shaft with AEG167 adjuster screws for road or race. When fitting make sure posts are equally tightened down this should eliminate stress fractures of the shaft.
Using 1.5 ratio high lift rockers has become very popular as they are effective at high revs
This 1.5 ratio forged rockers set will replace the standard versions and give significant gains on 1275cc units.Kit contains 8 rockers, adjusting screws, 4 steel pedestals and a heavy duty rocker shaft.
Valve clearances are recommended to be opened up by .003″ over recommended settings, although up to .005″ can be beneficial with certain combinations. Using the 1.5 ratio not only increases the maximum lift but it also means that the valve is open approximately 20% more at any given point- although opening and closing periods remain the same. This vastly improves volumetric efficiency and therefore power output
-
-
$9.38Add to cart
Hold Down Rod, For Battery (Rear)
Battery Rear Bolt – 6cm- Loop End
This rod fits on the back bracket by the positive earth terminal with a nut and bolt.
-
$36.58Add to cart
Oil Pressure Gauge Hose, Black. 11.75″ long.
Genuine
This thin hose joins # 21A804 and # CAM4202 metal oil pipes on the central speedo cluster Mini’s.
The clips for this part are # AAU1818
-
-
-
-
$15.40
Coil Mounting Bracket. For vehicles with a Generator, not an Alternator.
Refurbished Second Hand
-
-
-
$3.60Add to cart
Inlet Manifold Nut, Double Length Brass Nut.
Special extra long nuts were used on some manifolds. These nuts are about an inch long for easy reach and made of brass so they’ll never corrode. Especially handy on the inner two studs on dual carb set-ups.
Sold individually and usually 2 are used for the centre of the manifold.