You have no item(s) in your cart
Cooling and Heating
-
$2.82Add to cart
Thermostat Housing Stud 48mm (1.9375″) Long
This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required.
5/16″ unc and unf at nut end, this stud is about 5cm long about 4cm from the bottom of the UNC thread
-
$5.57
Thermostat Housing Stud, 48.mm (1.9375″) Set Of 3
This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required.
5/16″ unc and unf at nut end, this stud is about 5cm long about 4cm from the bottom of the UNC thread
-
$2.86
These are the special studs for the thermostat housing – 5/16 dia x 52mm o/all length with unc one end and unf the other.
Suits housings without engine steady bracket.
-
$5.25Add to cart
Thermostat Housing Stud, 76 mm
If your thermostat has a sandwich plate under it, you will need these longer studs. The washers are # GFK1114 and the nuts are # FNZ505.
5/16″ bolt 3″long, unc bolt with unf nut end.
Also used as a differential housing to case stud.
-
$82.50
Thermostat Housing, to suit Late 1275 Moke and 1275 LS Mini’s.
-
$28.14
Thermostat Housing, Plug in Top
New Old Stock
-
-
-
-
$18.76
Top Radiator Bracket
Mini Moke, 998cc, Late this type is fitted when the radiator inlet & outlet pipes are on the same side and the thermostat housing outlet point to the rear of the car.
Part number for Thermostat housing # CAM4044
-
-
$29.00Add to cart
Top Radiator Bracket
The upper radiator bracket was different on clubmans and was wider owing to the fact that a spacer was often used on the fan blade for clearance
-
-
$15.40
This hose suits cars where the top hose outlet points to the firewall of the car.
-
$28.33Add to cart
This hose suits cars where the top hose outlet points to the firewall of the car.