-
Battery Cable, 134" ( 3.4036 ) Metre Long
1 × $132.00 -
Clip, Interior Trim
2 × $2.86 -
Accelerator Cable, Rover Mini Single Point Injection
1 × $34.65 -
Exhaust Clamp, Manifold to Engine Pipe Quick fit
1 × $11.83 -
LAMP, FLASHER REAR AMBER (NO BULB)
1 × $12.93 -
BONNET LATCH
1 × $47.74 -
Filter Oil, Element - AJ 2.0L
1 × $11.94 -
HOSE CLIP MULTI USE
1 × $15.68 -
ENGINE OIL COOLER - 2.0 TiVCT PETROL TURBO
1 × $119.70 -
Setscrew, Multi use
4 × $1.05 -
HT Lead Ignition Spark Tester
1 × $49.50 -
Sensor, Brake Pad Wear Front
1 × $19.64 -
PROPSHAFT, FRONT - DISCOVERY 3/4/RANGE ROVER SPORT
1 × $455.46 -
WHEEL STUD, 9/16" BSF
1 × $4.13 -
ALTERNATOR - DISC/SPORT GENUINE
1 × $907.50 -
FILTER - AIR V12 upto '88 MANN
1 × $46.20 -
BALL JOINT, A FRAME. ADJUSTABLE & GREASEABLE
1 × $51.70 -
BALL JOINT, LOWER CONTROL ARM - DISCOVERY 3 & 4
1 × $23.87 -
Panel Clip to suit Land Rover and Jaguar
1 × $0.99 -
NYLOC NUT - MULTI USE
1 × $5.39
Brakes
- Sorry, this product cannot be purchased.
-
$2.53
LH & RH Front
Bleed nipple for front wheel cylinders on twin leading shoe type set ups, this is where you have 2 cylinders per hub
Will also fit front calipers on disc assemblies
-
-
-
-
-
Availability: This product is currently out of stock.
Brake Light Switch, Hydraulic, Multi Use
-
-
-
-
-
-
$5.50
Cap Master Cylinder, Early Plastic Lockheed Type 2/Hand
Has original Lockheed markings on cap. This is 2/Hand so may need cleaning.
This is the small master cylinder cap as fitted to both the brake & clutch master cylinders. This is the small cap and was fitted to the tin can master cylinders and some plastic master cylinders. This is about the size of a 50c piece
Plastic cap as supplied on single line brake cylinders pre 1976 and all clutch masters.
It doesn’t often break or wear out but it gets lost or turns yellow. The early steel master cylinder reservoir caps had a tendency to rust on, so this white plastic could be considered an upgrade unless you wish to keep your Pre 1963 car original with a metal cap 17H3723
-
$1.18
Brake Union Copper Washer between Banjo Bolt & 2-Way Brake Light Switch
This washer goes on the upper flange of the brake light switch union banjo bolt and on the upper banjo bolt for the rover/verto clutch hose.
The washer is is 17.4mm wide with an 11.4mm diameter hole. It is number 17 in the diagram below.
-
-
$0.55
Lock Nut, Brake Hose to Trailing Arm
Nut is 3/8″ UNF
Multi Use