You have no item(s) in your cart
Twin Carburettor Linkage Kit
SKU: MSSK009Available
$104.50
Twin Carburettor Linkage Kit
This kit will suit all the later 1.25″ and 1.5″ twin carb set ups where the balance rods between the carbs are equal in length (2.25″) Some early model carbs had the balance bar with a triangular plate, this is a shorter length.
Only 2 left in stock
Description
Kit contains;
Original type abutment bracket fitted to the inlet manifold to guide the accelerator cable
2 pairs of throttle and choke rod levers
A separate lever for the accelerator cable
One lever is also supplied for throttle lever
The coarse thread UNC bolt for the abutment bracket to manifold needs to be shortened to the correct length for all the later type manifolds.
If you are looking for original HS2 centre rod with balance bar use # 12A310
Additional information
| Weight | 1 kg |
|---|---|
| Dimensions | 15 × 15 × 10 cm |
Related Products
$13.00
Cylinder Head Stud, Short (11 cm)
$0.66
Heater Tap & Blanking Plate Gasket
$9.90
Competition Grade head (spring) washers, set of 10. Original ST spring type washer especially required...
$2.86
These are the special studs for the thermostat housing - 5/16 dia x 52mm o/all...
$544.50
Side Panel Rear Quarter Right Hand Side, UK Mini
$24.20
Thermostat Housing, Standard Alloy